30 มี.ค. 2012 determine if it exceeds knots IDC connector
An aluminum johnboat that’s less than Din41652 connector feet long and powered by oars or a sail doesn’t require hard-wired lights, according to the Coast Guard’s Navigation Rules. However, you must carry a flashlight close at hand to alert other vessels to your presence. If your johnboat has a motor, is less than feet in length and can’t exceed a speed of knots hxtf3imq, you only need wire to it for a single white stern light visible from any direction. If the vessel can exceed knots, it must display a combined red and green bow light along with the white stern light.
Inspect the boat to determine if it is powered by oars, sail or a motor Waterproof connector , including a trolling motor.
Inspect the boat’s title or Certificate of Number — its state registration — and determine its length. If the boat is not registered or titled, measure the length of the boat with a measuring tape. If the vessel is powered by oars or by sail and is less than feet long, place a flashlight in the vessel to satisfy the vessel lighting requirements.
Go boating during the day if your boat has a motor, and carry a portable GPS with you. Accelerate to full speed and take note of your vessel’s speed — according to the GPS — to determine if it exceeds knots IDC connector .
Johnboat With a Motor Measure the diameter of a standard stern-light pole base with calipers. Secure a hole saw of that diameter into a drill. Drill a hole in the gunwale — the flat, rolled top of the back of the boat. Push the base of the stern-light pole base through the hole until the flange is against the gunwale. Use an electric screwdriver to secure the flange of the stern-light pole base to the gunwale with self-tapping screws.
Cut two pieces of -0 AWG gauge stranded-copper wire — one piece covered with red insulation, the other in black insulation — of sufficient length to reach from your boat’s battery to the base of the stern-light pole base. Strip / inch of insulation from each end of both wires, using a wire stripper. Crimp a ring terminal sized to fit the battery’s posts onto one end of each length of wire, using a pliers-type wire crimper. Crimp the male half of a bullet ip67 connector to the other end of each length of wire.Related Articles:DIN41612 Connector-Serial 2B-Male connector